RELIEF

SURFACE PREPARATION Surfaces should be smooth, clean and dry, free from grease, dust, loose or flaking paint. To fill any cracks or holes use Acrylic Putty. New surfaces made of plaster, concrete, cement, plasterboard, or surfaces previously covered with water paints or distempers (i.e. limewash or ceilling white) should be primed with Durovit or Acrylan Unco. APPLICATION Stir well before use. Apply with a common roller. Before the coating dries, a special roller is used to produce the desired textured pattern. In case a finer textured pattern is desired, dilute 5 – 10% with water. Do not apply at temperature below 5°C, above 35°C and / or relative humidity above 70%. Avoid application when rain or frost is expected in the next 48 hours. It is touch-dry after 20-30 minutes. It can be redecorated with any VITEX acrylic or emulsion paint, after the surface has been cleaned. The coating obtains its final hardness about one week later. Drying time depends on weather conditions (humidity and temperature). Tools must be cleaned immediately after use with water and if needed with soapy water or a detergent.